Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
3
Contents of Crate
•
One Lawn Tractor
•
One RZT Tractor Operator's
Manual
•
One Oil Drain Tube
•
One Kawasaki Engine Operator's
Manual
•
One Deck Wash Hose Coupler
•
One Product
Registration
Card
TRACTOR P REPARATION
Remove the upper crating material from the shipping
pallet, and cut any bands or tie straps securing the tractor
to the pallet.
Use the lift handle to raise the deck to its highest position.
Engage the transmission
bypass rods on each side of the
tractor; then carefully roll the tractor off the shipping
pallet. Disengage
the bypass rods. See Figure 3-1.
RH
Bypass Rod
PullOut
_ass Rod
_Then
Lower
In Slot
Keyhole
Slot
Figure 3-1
Remove the deck wash system nozzle adapter and oil drain
tube from the manual bag and store for future use.
Install Operator'sSeat
The operator's
seat was partially
inserted
into the seat
pivot bracket for shipping
purposes. To install the seat
proceed as follows:
I.
Cut any straps securing the seat assembly and the
drive control levers to the tractor. Remove any packing
material.
NOTE: The seat is partially
inserted into the slots of the seat
pivot bracket. If the seat does not become disengaged from
the pivot bracket when removing the packaging
material, the
pivot bracket may be pivoted upward and the seat pushed
into place as described in step 6. If the seat does disengage the
pivot bracket, install the seat as instructed in steps 2 thru 6.
2.
Pivot the seat pivot bracket partially
upward. Refer to
Figure 3-2.
3.
Note the grooves in the seat adjust spacers attached
to the bottom
of the seat, then lift the seat and
position
above and to the rear of the pivot bracket.
4.
Align the grooves in the seat adjust spacers with the
sides of the adjustment
slots in the pivot bracket.
5.
Slide the seat adjust spacers into the slots of the pivot
bracket.
6.
Continue to push the seat forward
in the pivot bracket
until the front/left
shoulder bolt of the seat assembly
passes forward
of the stop bracket on the seat pivot
bracket. See Figure 3-2.
Use the seat adjust lever to adjust the seat position.
Refer
to "Adjusting
the Operator's
Seat" in Section 3 for seat
adjustment
instructions.
Seat_
Seat
Bracket
Seat
Front/Left
SeatAdjust
ShoulderBolt
StopBracket_;
Lever
Figure 3-2
Publicidad
