Reduce Tipping Radius; Install Anti-Tip Boards - Thermador KBULT3651A Instrucciones De Instalación

NOTE: Pass the dolly strap under the handles for the Curved
and Professional Series.
3. Place pieces of the shipping carton on the floor when rolling
the dolly and refrigerator into the house. Move the refrigerator
close to the built-in opening.
NOTE: If necessary, reduce the tipping radius. See "Reduce
Tipping Radius."
R e d uc e T i p p i ng Ra di u s
( if re q ui re d )
Before bringing the refrigerator into the home, be sure there is
adequate ceiling height to stand the refrigerator upright. See
"Tipping Radius" in the "Design Specifications" section for more
information.
If you do not have adequate ceiling height to stand the
refrigerator upright, the tipping radius can be reduced by
removing the top grille and side trims (see the following chart).
Model
36" (91.4 cm)
Custom Panel Series
1. Grasp both ends of the top grille.
2. Push the top grille straight up; then pull straight out. Lay the
grille on a soft surface.
B
A. Top grille
B. Cabinet side trim
3. Remove the six screws attaching each cabinet side trim to
the refrigerator and remove the side trims.
4. Stand the refrigerator up. First, place the left bottom edge of
the refrigerator on the floor, stand the refrigerator upright, and
then lower the right-hand side of the refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
16
Reduced Tipping Radius
88" (223.5 cm)
A B
Curved Handle and Professional Handle Series
1. Grasp both ends of the top grille. Push the top grille straight
up; then pull straight out. Lay the top grille on a soft surface.
B
A. Top grille
B. Cabinet side trim
2. Remove the six screws attaching each cabinet side trim to
the refrigerator and remove the side trims.
3. Stand the refrigerator up by first placing the left bottom edge
of the refrigerator on the floor, standing the refrigerator
upright, and then lowering the right-hand side of the
refrigerator down to the floor.
4. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
I n s t a l l A n t i - T i p B o a rd s
IMPORTANT:
The solid soffit must be within 1" (2.5 cm) maximum above
the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or
one is not available, prevent the refrigerator from tipping
during use.
It is recommended that board(s) be installed before the
refrigerator is installed.
Board(s) must be long enough to fully cover the width of the
compressor cover.
Locate the board(s) so the bottom surface(s) of the board(s)
is(are) 84" (213 cm) from the floor.
During installation, raise the refrigerator up so there is ¹⁄₄"
(6.35 mm) maximum between the top of the refrigerator and
the bottom of the anti-tip board(s). Do not crush the
condenser cover when raising the rear leveling legs.
A B