Safety Warning; Disposal Of Product; Compliance With Ec Regulations; Determining The Position Of The Ct02 - Favero CT02 Manual De Instalación

ENGLISH
Max contact
current..................:
Minimum contact
current....................: 5 mA
Switching voltage...: 250 Vac max, 10V min.
Temperature operating..
Temperature storage.
Relative humidity
without condensation....
Output for Solenoid
valve...............................:
lnternational Protection
Rating
1.4 Guarantee
The guarantee is valid for two years starting from
the date of purchase and includes free repair for
any defects in materials or construction. The
guarantee does not include shipping costs.
More information on guarantee and post-sale
support can be found at

1.5 Safety warning

WARNING: The CT02 should be installed
by a qualified
compliance with regulations in effect in
the country where
place.

1.6 Disposal of product

Please dispose of your product in a manner most
compatible with the environment and in accordance
with federal or state laws, reusing parts and
recycling components and materials when possible.
When this crossed-out waste bin symbol is
attached to a product it signifies the product
should be disposed of in a separate
container from other waste. The sorted
waste collection of the present device is
organized
manufacturer. Users who wish to dispose of
their present device should contact the
manufacturer and follow the procedure
indicated for separate waste collection.
1 Usage category AC1 and AC15 according to EN60947-4-1 and EN60947-
5-1
00182-M06-01-ML Installation manual CT02
10 A, with resistive load
AC1 1
3.3 A, with inductive
load AC15 1
0 ... +50 °C
:
-20 ... +85 °C
:
20 – 90% (operating
and storage)
:
12 Vdc, 0,8A max
(9,6W)
IP54
www.favero.com .
technician
installation takes
and managed
Ensuring proper sorted waste collection in
accordance with environmental standards for
the disposal of further devices helps to
protect the environment and the health of
persons from any damaging effects. It also
favors the reuse and recycling of materials.
Administrative sanctions, in accordance with
regulations in effect, will be applied for any
improper or abusive disposal of the product
on part of the holder.

1.7 Compliance with EC regulations

The CT02 meets the necessary requirements for
electromagnetic
regarding
European regulations:
• 2004/108/EC of 15 December 2004
• 2006/95/EC of 12 December 2006
2 M
If possible, protect the product from direct contact
with rain, sunlight, heat, water jets.

2.1 Determining the position of the CT02

Determine the position of the CT02 by paying
attention to:
The regulations of the country in which it is to be
•
installed with regards to the position of electric
devices in special areas (showers, swimming
pools, etc.).
and in
Decide on the position by also taking into
•
consideration the path of the connection cables.
See chapter 3 for information on connections.

2.2 Mounting to wall

Remove the front cover by unscrewing the four
•
screws.
Fasten the CT02 via the 4 holes at the bottom.
•
Proceed with the electrical connections as
•
indicated in chapter 3.
Replace the front cover.
•
3 E
LECTRICAL
WARNING:
installed by a qualified technician and in
compliance with the regulations in effect
by the
in the country where installation takes
place.
The cables entering the CT02 must be
double isolation cables.
Pag. 4 / 24
Compatibility
electronic equipment,
T W
OUNTING O ALL
C
ONNECTIONS
Make
and Security
according
sure the CT02
F E D
AVERO LECTRONIC ESIGN
to
is