Fellowes FORTISHRED HS-440 Manual De Instrucciones página 5

ADVANCED PRODUCT FEATURES
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However,
on rare occasions the sensors may become blocked by paper dust causing the
motor to run even if there is no paper present
located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Turn off and unplug Locate Auto-start
shredder
infared sensor
TROUBLESHOOTING
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053.
Safety Shield Indicator: When flashing alternatively with On/Off ( ) LED, safety shield is open and shredding will stop. To resume shredding, make sure safety shield is closed.
Door Open Indicator: When flashing alternatively with On/Off ( ) LED, the door is open. To resume shredding, make sure the door is closed.
Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will automatically stop and reverse paper. If necessary, press (R) to run shredder in
reverse. See Paper Jam section below.
R
Overheat Indicator: When flashing alternatively with On/Off ( ) LED, shredder requires a 10-15, minute cool down period. When ( ) is blue, resume shredding.
PAPER JAM
1 2
Gently pull uncut paper
When flashing blue,
from paper entry.
too much paper is
inserted. Shredder
will automatically stop
and reverse paper.
Safety Shield
Electronically controlled shield stops
shredder when opened for advanced safety
(Note: two paper detection sensors are
3 4
Use thin, long-handled brush Clean any contamination
to clean sensors. Make sure
from the paper sensors
brush is clean and dry
3 4
Shred 1 sheet of
If necessary, press
Reverse (R) to run paper to clear
cutters. Resume
shredder in reverse and
then pull uncut paper normal shredding.
from shredder.
30
OILING SHREDDER
All high security shredders require oil for peak performance. If not oiled, a machine
may experience diminished sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we recommend you oil your shredder
each time you empty your waste bin or every 15-30 minutes of continuous use.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Apply oil
Set to Off ( )
and unplug across entry
Important: For optimal shredding perfomance, use Fellowes High Security
oil (3505701). *Use of standard shredder oil is not recommended.
Auto Shut Off
After 30 minutes of inactivity, shredder
automatically turns off for zero energy
consumption
3
Press Reverse (R)
3