Carel pCO3 Hoja De Instrucciones página 17

pCO 3 : assigning the list of private and shared terminals
At this stage, to modify the list of terminals associated with each individual pCO
• enter confi guration mode by pressing the  buttons, as described in the previous paragraph;
• press the  button until the cursor reaches the fi eld xx (I/O board address) ;
• use the  buttons to select the desired address of the pCO
line. If the pLAN network is not operating correctly, or alternatively no pCO
show "—";
• pressing the  button again displays the following screens in sequence:
Terminal Config
Press ENTER
to continue
P12:Adr Priv/Shared
Trm1 02 Sh
Trm2 03 Pr
Trm3 None --OK?NO
• here too the  button moves the cursor from one fi eld to another, and the  buttons change the value of the current fi eld.
The fi eld P:xx shows the address of the board selected; in the example shown in fi gure, the address 12 has been selected;
• to exit the confi guration procedure and save the data, select the fi eld "OK ?" and set to Yes, then confi rm by pressing the  button.
The fi elds in the "Adr" column represent the addresses of the terminals associated with the pCO3 board address 12, while the Priv/Shared column indicates
the type of terminal.
Important: the pGD terminals cannot be confi gured as "Sp" (shared printer), as they do not have the printer output. If the terminal remains inactive (no
button pressed) for more than 30 seconds, the confi guration procedure is automatically ended without saving any changes.
NOTES ON USING WINLOAD, BOOT AND BIOS
The most recent version of WinLoad should always be used. Management of the pCO
com. From version 3.36, the download speed for the Bios and the application to the pCO
28800 bit/s, however this change does not require any new settings by the user.
The pCO 3 BIOS and the BOOT are specifi c fi les, and different from the pCO
the pCO 3 , and, obviously, the pCO
4
3
2
1
5
6
+050003290 - 1.6 - 03.08.2011
1 and pCO 2 BOOT and BIOS cannot be loaded onto the pCO
GUIDELINES FOR DISPOSAL
• Do not dispose of the product as municipal waste; it must be disposed of through specialist waste disposal centres.
• The product contains a battery that must be removed and separated from the rest of the product according
to the instructions provided, before disposing of the product.
• Improper use or incorrect disposal of the product may negative effects on human health and on the environment.
• The public or private waste collection systems defi ned by local legislation must be used for disposal.
• In the event of illegal disposal of electrical and electronic waste, the penalties are specifi ed by local waste
disposal legislation.
3 board, proceed as follows:
3 board. The values that can be selected refer to the pCO
3
board is connected, the fi eld will not be able to be modifi ed and will only
3 is supported by WinLoad version 3.35, available at http://ksa.carel.
3 has been increased to 115200 bit/s from the standard speed of
1 and pCO 2 BIOS and BOOT fi les. Consequently, these cannot be loaded onto
17
3 boards that are effectively on
3 .