Turning The Power On And Off; Switching Audio Modes; Adjusting Volume - Fujitsu Ten ECLIPSE CD3100 Manual Del Propietário

Turning the power on and off

When the power is turned on, the state used
when the power was turned off such as CD and
tuner playback is restored.
When power is OFF, press the
1
[SOURCE/PWR] button.
The power will come ON.
ATTENTION
When the main unit's power is turned on for
the first time or if the battery terminals have
been disconnected because of a reason
such as vehicle maintenance and the power
is then turned back on, the main unit will
start up in FM1 mode. After this, the
broadcast stations will be searched for
automatically and stored in buttons [1] to
[6].
When power is ON, press the
2
[SOURCE/PWR] button until you
hear a beep (for more than one
second).
The power will go OFF and the main
unit will be in Standby.

Switching Audio Modes

Press the [SOURCE] button for
1
less than one second.
Press the button to switch mode in the
following sequence:
*1
FM/AM → SIRIUS → XM
*2
→ CDC
CD (MP3/WMA)
*1
→ FM/AM → ⋅ ⋅ ⋅ ⋅
iPod
*1: Cannot be selected if the corresponding
device is not connected to the main unit.
*2: Not displayed if no disc is inserted.
*3: Cannot be selected if the AUX mode is not set
to ON. For details, refer to "Switching the AUX
mode on and off" on page 61.
*1
→
*1 *3
→ AUX →
Names of controls and parts
ATTENTION
The currently selected
displayed in the upper right corner of the
screen. (When the switching screen is set to
normal - see page 17).

Adjusting volume

1
Turn the [VOL] button.
Turn to the right: Increases the volume.
Turn to the left: Decreases the volume.
ATTENTION
Press the [MUTE/Area Shot] button for less
than one second to cut the volume or restore it
instantly.
CAUTION
Do not adjust the volume or other controls
while driving the vehicle. Do so only while
parked in a safe location.
audio mode is
Current audio mode
15
III