Assembling The Blower - Shindaiwa EB630 Manual Del Operador

Assembling the Blower (EB630)
IMPORTANT!
This unit is equipped with a static dis-
charge reduction wire. This wire helps
direct static buildup into the air stream
reducing the felt amount to the operator.
1. Place the blower upright on the ground
or a sturdy work surface and note parts
orientation as shown in figure 4.
2. Remove static wire from package and
fix eyelet to right hand engine cover
screw. See Figure 5.
3. Turn the dicharge tube out to a right
angle and slip anti-static wire through
the 100mm clamp and flexible tube.
4. Slip the flexible tube over the end of the
90° discharge tube, and secure with the
100mm clamp.
NOTE:
Check to make sure that the 90
tube swivels freely from front to back. If any
binding is present, loosen 100mm clamp and
pull wire towards engine to get more slack
and recheck for free movement.
5. Insert the static wire through the swivel
tube, then install and tighten the 85mm
clamp over the rotating band on the
swivel tube.
6. Slide the handgrip over the swivel tube
and secure with the bolt and wingnut.
7. Fold the end of the static wire back over
the connection of the swivel tube.
See Figure 5.
8. Grasp the straight tube, and push the
tube over the swivel tube locking pins
securing the static wire. See Figure 6A.
9. Lock the straight tube to the swivel tube
by rotating the straight tube.
10.Grasp the nozzle tube and lock the
nozzle to the straight tube noting the
alignment marks. See Figure 6B.
6
Anti-Static
Wire
Figure 4
0 discharge
Static Wire
Connector
Figure 5
Blower tube installation affects blower
performance! Make sure the tubes and
nozzle are correctly assembled per
above, and that all connections are tight.
Blower tubes may come apart during use
unless tubes are aligned and locked into
place.
Swivel
Tube
Flexible Tube
90° Discharge
Tube
100mm
85mm
Clamp
Clamp
Swivel
Tube
Fold Wire
Static Wire
Flexible Tube
IMPORTANT!
Handgrip
Straight
Tube
Swivel
Tube
Align the lock pins with the
lock slots, and push the
tubes together.
A
Lock Pin
Lock Slot
Rotate clockwise to lock
making sure the 3 lines are
aligned on both tubes.
B
Figure 6
WARNING!
Danger from rotating impeller!
Stop the engine before installing or
removing the blower tubes! Never
perform any maintenance or
assembly procedures on this unit
while the engine is running!
Nozzle