Setting Up - Atmospheric Water Solutions AquaBoy Pro II Manual Del Usuario

7. SETTING UP

THE APPLIANCE MUST BE IN AN UPRIGHT POSITION FOR
24 HOURS BEFORE BEING PLUGGED IN.
Read this User's Manual completely and carefully before plugging in your appliance.
1. After unpacking, wait at least 24 hours before plugging the appliance in. Plugging in
immediately may damage the compressor.
Appliance must be placed indoors, upright on a solid and level floor.
2.
The appliance must be placed at least 12 inches (30 cm) from any wall or other structure and in a
3.
room with good air circulation.
Tighten all filters before plugging appliance in (reference picture 2.2-4 on page 10).
4.
Plug the appliance into electrical outlet capable of handling no less than 10A.
5.
Priming the unit; this step will require 3 gallons of purified or distilled water.
6.
a. Using a Phillips screwdriver, remove both screws from the back bottom plate (picture 2.4-2
on page 12).
b. Replace right screw in order to prevent flashing of number 2 filter light.
c. Carefully grab bottom tank handle and pull out halfway towards you without interfering with
tubes and wires (picture 2.4-3 on page 12).
d. Slowly fill the lower storage tank with purified or distilled water.
e. Allow lower tank to drain at least half way and then fill tank again; repeat this step until 3
gallons of distilled or purified water have been dispensed into the appliance.
f. Carefully replace the bottom tank and back bottom plate.
g. Allow up to three hours for the water recirculation process to occur.
Water Hose Kit (supplied). The AquaBoy
7.
to be used to supplement the water being made from the air. This ensures that an endless supply
of pure great tasting water is available under conditions of heavy use, or periods of low humidity.
The enclosed blue hose can be attached to the water inlet on the lower back of the appliance and
then the other end of hose can be attached directly to the supplemental water source (for example:
a faucet, tap, water line, separate water tank, etc.). This appliance will automatically switch to using
your supplemental source if the water in the appliance tanks is below the level required to dispense,
or if the relative humidity is below 32%. Please note that a fitting or adapter other than the on
included with the kit may be needed for some applications. If you have any questions, please
contact our Customer Service Team at 954-306-6763, or your local plumber.
Remove the plastic film from the control panel display. The appliance is now ready for use.
8.
Pro II has an inlet that permits additional water sources
®
www.AtmosphericWaterSolutions.com 6