Profile PIN-116 Manual De Instalación página 11

MULTIMETRE MEDIUM
PIN-116
Replacing the fusing
Warning! To prevent electric shocks you must
disconnect the testing wires from any power sources
before you open the cover of the fuse compartment.
1. Disconnect the testing wires from the metre and
all items to be tested.
2. Remove the rubber housing
3. Open the fusing compartment cover by removing
the screw in the cover.
4. Remove the old fusing from the compartment by
carefully pulling it out.
5. Place the new fusing in the holder.
6. Always use fusing of the correct size and
specification (10A/250V fast-reacting for the 10A
range).
7. Replace the fusing cover. Insert the screw and
tighten firmly.
Warning! To prevent electric shocks you may not
use the metre until the cover of the fuse
compartment has been replaced and fastened.
Specifications
Overvoltage category: CATII
Display: 2,000 counts
Polarity: Automatic, (-) indication negative polarity.
Various Graphics
DC voltage
Range Resolution
200mV 0.1mV
2000mV 1mV
20V 0.01mV
200V 0.1mV
600V 1V
AC voltage
Range Resolution
200V 0.1V
600V 1V
Direct current
Range Resolution
2000 μ 1 μA
20mA 10 μA
200mA 100 μA
10A 10mA
Resistance
Range Resolution
200 Ω 0.1 Ω
2000 Ω 1 Ω
20k Ω 0.01k Ω
200k Ω 0.1 k Ω
2000k Ω 1 k Ω
Temperature
Range Resolution
-20°C ~+760°C 1°C
-4°F ~1400°F 1°F
Diodetest
Test current
Max 1mA
Open circuit voltage: 2.8 V DC typical
Accuracy
+/- 0,5% van rdg
+/- 2- figures
+/- 0,8% van rdg
+/- 2- figures
+/- 1% van rdg
+/- 2- figures
Accuracy
+/- 1,2% van rdg
+/- 10- figures
50/60Hz
Accuracy
+/- 1% van rdg
+/- 2- figures
+/- 1.2% van rdg
+/- 2- figures
+/- 3.0% van rdg
+/- 2- figures
Accuracy
+/- 0.8% van rdg
+/- 2- figures
+/-1.2% van rdg
+/- 2- figures
EN - 3