Publicidad
Idiomas disponibles
Idiomas disponibles
i
,Ik Warning:
Read Owner's
Manual.
Do not attempt
I
to operate
equipment
until you have read Owners[
Matruua_cJOrnSafety, Operation,
and Maintenance
I
Note: Included with your unit is a video cassette that
demonstrates how to operate your pressure washer.
tf you have a video cassette recorder you should
view the video before operation,
,& Warning:
Never adjust spray pattern when spray-
ing. Never put hands
in front of spray
nozzle
to
adjust
spray
pattern
because
you could
be
injured.
Adding
Pump Oi[
Before running the high pressure washer, check the
pump oil level by viewing the sight gtass on the side
of the pump, When properly filled, the oil will be at
the half way point marked by the two triangles. Your
pressure washer pump is shipped with oil, Add oil
only if oil level is lower than the half way point on the
sight glass. Do not overfill, Use 30 weight non-
dete;gent oil if necessary.
,& CAUTION: Do Not use engine oil that has been
[
shipped with your unit in your pump, Engine oil
I
is detergent and your pump uses a non-detergent
[
oil. Detergent oil can cause damage to your pump,j
Stopping
Your Pressure
Washer
A CAUTION:
Do not run pump without
the water
supply
connected
and turned on. Failure to do so
will result in pump damage.
To turn pressure
washer off place the on/stop
switch
to the stop position,
Simply
shutting
OFF engine wig not release
pressure
in the system.
Squeeze
the trigger
on the
spray gun for about
3 seconds
to relieve
pressure_
Spray stream
wi!I decrease
in length.
iMPORTANT:
This unit is equipped
with a therma;
relief valve,
if unit is allowed
to run for severaI m;n --
_Jtes without
pressing
the trigger on the spray gun,
several drops of water may be released through
this
valve to cool the unit. The heated
water will be pb_rged
from the bottom
of the pump.
BEFORE
STARTING
THE
ENGINE
To operate the engine you wilt need to do the following,
A CAUTION: Always check engine oil levei before
every staR. Running engine !ow of oil or out of oil
couId result in serious damage.
A CAUTION: Always check pump oil Ievei before
_,
every start, Running pump low on oil couId ,_-esu!t
in pump damage.
"
Engine
Oil
Your unit has been shipped
without
oil in the engine.
A bottle of SAE 30 weight
oil is included
in the carton.
Remove
oil plug located
on the side of engine.
Using a
funnel
fill engine crankcase
up to the last thread in the
oil port. Pour slowly. Oil reading will be inaccurate
on
unlevet ground.
NOTE_ When adding
oil to the engine
crankcase;
use
a high quality
detergent
oil classified
"For Service
SF,
SG, SH rated
SAE 30 weight.
Use no special
addi-
tives, Select
the oiFs viscosity
grade
according
to
you expected
operating
temperatures.
SAE
Vi.'_eesity
Grades
Air cooled
engines
run hotter than automotive
engines.
The use of multi-viscosity
oil such as (10W-30,
etc.) in
ambient
temperatures
above 40°F (4°C) will result in
higher than normai oil consumption.
If multFviscosity
o]i is used, check the oi_ level more frequentIy
to
prevent
any posssible
engine damage
due to lack or
lubrication.
Use of SAE30 oil below 40°F (4°C) will result in hard
starting
and possible
engine damage
dL_e to inad-
equate _ubrication.
Publicidad
