Siemens Sitrans LVS100 Manual De Instrucciones página 18

Sensitivity
If the measured material tends to cake or build up, the sensitivity adjustment switch can
be set to position A to decrease the sensitivity of the probe (factory setting is position B).
The sensitivity for interface applications should be set to position B, while the setting for
high-flow applications should be position A.
LVS100
LVS200
Page EN-16 SITRANS LVS100/200 – INSTRUCTION MANUAL
FSH/FSL adjustment or
High/Low Alarm setting
sensitivity adjustment:
B = factory setting
A = decreased sensitivity
FSH/FSL adjustment or
High/Low Alarm setting (NAMUR)
sensitivity adjustment:
B = factory setting
A = decreased sensitivity
7ML19985FT63