Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BACK
WiFi LED
Full HD LED
HD LED
VGA LED
Mode Selection Switch
Accessory Installation Port
PREPARATIONS
CHARGING
* Battery pack is not inserted in the product. Also, battery is not fully charged at the
time
of purchase. Charge the battery before starting to use the product.
1.
The rating label which mentions product name; etc. is attached at the bottom of the
product (①). Slide 2 knobs to the opposite directions of the arrows on the label and
unlock. Slide and open the slot. Insert the battery pack. Slide and close the slot.
Lock the knobs.
2.
Turn off the product. Charging is not possible while the power is on.
3.
Open the micro USB port cover. Connect the micro USB plug (smaller one) of the
supplied USB cable to the micro USB port of the product.
4.
Connect the USB plug of the USB cable to a USB port on your computer. Battery
charging starts.
[Power LED] on the product blinks in red while charging.
5.
Battery is fully charged when [Power LED] turns red.
①
Mic
Lock
Back Cover
(WiFi card slot inside)
micro USB
micro USB Port
Battery slot
7
Publicidad
Tabla de contenido
