General Electric PBM21 Instructivo Y Advertencias página 60

HOW TO REPLACE THE FREEZER DRAWER (in some models).
It might be required two people to complete
this procedure
INSTALL AND ASSEMBLE THE FREEZER
DRAWER TO THE CASE SLIDES
Pull the support slides to the maximum extension
position at each side
Find and locate the slots in the inside of the slides,
near the back end of them.
Insert the drawer bracket hooks (on each side)
into the slides slots, located near the back end of
the slides.
Lower the front end of the Freezer drawer, make
sure that the side tabs on the metal bracket, fit
completely inside the slots in the case slides.
Installation Instructions
Slot
Hook
Tab
60
Install and assemble the Freezer
Drawer to the case slides (continue...)
Replace the safety screws back into both slides
assembly
IMPORTANT:
Tighten the slides screws to
10-15 in-lbs.
Screw