General Electric PBM21 Instructivo Y Advertencias página 64

REMOVE THE FREEZER DRAWER
3
Refer to the removing the freezer drawer section for
3.1
instructions.
REPLACING THE DOORS
4
follow these same instructions in reverse from the point 3 to 2.
4.1
NOTE: Tighten the screws hinge to 60 in-lbs.
REHANG LEFT REFRIGERATOR DOOR
5
Lower the refrigerator door onto the center hinge pin.
5.1
Ensure that the plastic thimble is on the center hinge pin
(For models without Ice & Water door)
5.2
Pass the wire through the hinge slot. Insert the top hinge
into the door. Make sure the door is aligned with the cabinet.
Attach the hinge to the top of the cabinet loosely with the
screws.
Make sure the gasket on the door is flush against the cabinet
and is not folded. Tighten the screws to 60 in-lbs.
Installation Instructions
Plug in the wire connector and route the wire inside the
5.3
plastic part.
REHANG LEFT REFRIGERATOR DOOR
6
6.1 (For models with Ice & Water door)
Make sure the door is aligned with the cabinet. Attach the
hinge to the top of the cabinet loosely with the screws.
Make sure the gasket on the door is flush against the cabinet
and is not folded. Tighten the screws to 60 in-lbs.
64