Ice & Water - LG LSXC22486 Serie Manual Del Usuario

50 TROUBLESHOOTING
Ice & Water
P o r b e l m
Icemaker is not Refrigerator was recently
making enough installed or icemaker recently
ice (continued). connected.
Icemaker not turned on.
The ice detecting sensor is
obstructed.
The refrigerator is not
connected to a water supply
or the supply shuto valve is
not turned on.
Icemaker shuto (arm or
sensor) obstructed.
Ice has bad Water supply contains
taste or odor. minerals such as sulfur.
Icemaker was recently
installed.
The food has not been
stored properly in either
compartment.
The interior of the refrigerator
needs to be cleaned.
The ice storage bin needs to
be cleaned.
Icemaker is Icemaker shuto (arm/sensor)
making too is obstructed
much ice.
P o s s b i e l C a u s e s S l o
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker
to begin making ice.
Locate the icemaker ON/OFF button on the display
and confi rm that it is set to the Ice On mode.
Foreign substances or frost on the ice-detecting
sensor can interrupt ice production. Make sure
that the sensor area is clean at all times for proper
operation.
Connect the refrigerator to the water supply and
turn the water shuto valve fully open.
If your icemaker is equipped with an ice shuto
arm, make sure that the arm moves freely. If
your icemaker is equipped with the electronic ice
shuto sensor, make sure that there is a clear path
between the two sensors.
A water fi lter may need to be installed to eliminate
taste and odor problems. NOTE: In some cases, a
fi lter may not help. It may not be possible to remove
all minerals/odor/taste in all water supplies.
Ice that has been stored for too long will shrink,
become cloudy, and may develop a stale taste.
Throw away old ice and make a new supply.
Rewrap the food. Odors may migrate to the ice if
food is not wrapped properly.
See the Care and Cleaning section for more
information.
Empty and wash the bin (discard old cubes).
Make sure that the bin is completely dry before
reinstalling it.
Empty the ice bin. If your icemaker is equipped
with an ice shuto arm, make sure that the arm
moves freely. If your icemaker is equipped with the
electronic ice shuto sensor, make sure that there
is a clear path between the two sensors. Reinstall
the ice bin and wait 24 hours to confirm proper
operation.
t u o i n s