U S E - CS Unitec MABasic 200 Instrucciones De Manejo

U s e

U s e
S e l e c t t h e r o t a t i n g s p e e d r a n g e
( o n l y M A B a s i c 4 0 0 , 4 5 0 a n d 8 5 0 )
ATTENTION
► Switch the gear stages only with the
machine at standstill.
NOTE
► Select the speed range according to
the material and drilling diameter.
Se l e c t t h e g e a r M AB a s i c 4 0 0 / 4 5 0
The machine has a gearbox with two
mechanical gear stages. The rotation speeds
of the gear stages are specified in the
technical data.
To select the desired gear stage, set
‹
selector lever on the gearbox (3) to
stage 1 or 2 with the machine switched
off.
Se l e c t t h e g e a r M AB a s i c 8 5 0
The machine has a gearbox with four
mechanical gear stages. The rotation speeds
of the gear stages are specified in the
technical data.
To select the desired gear stage, switch
‹
the machine off and set both selector
levers on the gearbox (5) to the desired
stage as shown in the table below.
Ge a r s t a g e
a n t i - c l o c k -
w i s e
Stage 1
Stage 2
Stage 3
Stage 4
1 6
Se l e c t o r l e v e r
c l o c k w i s e
▼ ▲
▼ ▼
▲ ▲
▲ ▼
A c t i v a t i n g / d e a c t i v a t i n g
t h e m a g n e t i c c l a m p
Ac t i v a t i n g t h e m a g n e t i c c l a m p
ATTENTION
► To prevent the magnet from
overheating, switch on the magnetic
clamp only when the machine is
standing on a magnetic substrate.
Turn on the switch (11). The indicator
‹
lamp in the switch (11) lights up.
ATTENTION
► The maximum magnetic clamping
force is only available after
switching on the motor.
D e a c t i v a t i n g t h e m a g n e t i c c l a m p
Hold the handle tightly (5) to stop the
‹
machine from slipping.
Turn off the switch (11). The indicator
‹
lamp in the switch (11) extinguishes.
S w i t c h i n g t h e m a c h i n e ON / O F F
Using the ON/OFF switch (10), turn the
‹
machine ON with the green button (I)
and OFF with the red button (O).
NOTE
► The machine can only be switched on
when the magnetic clamp has been
switched on.
► Allow a severely overheated machine
to run on at idle speed for approx. 2
minutes to cool it down.
► The machine switches off automatically
in the event of a power failure or if the
magnetic clamp is switched off.
M A B a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0