El I M I N A T I N G B L O C K A G E S - CS Unitec MABasic 200 Instrucciones De Manejo

D r i l l i n g w i t h t h e m a c h i n e
D r i l l i n g w i t h c o r e d r i l l s
When drilling with core drills, proceed as
follows:
Insert the corresponding ejector pin (23)
‹
into the core drill.
Insert the core drill with the ejector pin
‹
as described in chapter Inserting the
tool.
Place the machine at the working
‹
location, align it and switch on the
magnetic clamps.
Switch the machine on.
‹
Direct the drill with the handle (6) to the
‹
material.
NOTE
Observe the following instructions when
drilling with core drills:
► Drilling with core drills does not require
great force. The drilling process is not
accelerated by higher pressure. The
drill wears faster and the machine can
be overloaded.
► Use CS Unitec's high-performance
cutting oil in the cooling lubricant
system of the machine.
► The cooling lubricant system cannot be
used when working overhead. In this
case, use the high-performance ZHS
400 grease spray.Spray the drill on
the inside and outside before drilling.
Repeat this procedure when drilling
deeper holes.
► Make sure that swarf is removed
regularly. With larger drilling depths,
break the chip.
M A B a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0
E l i m i n a t i n g b l o c k a g e s
E l i m i n a t i n g b l o c k a g e s
W AR NING
D a n g e r o f c u t i n j u r i e s f r o m
p a r t s o r s w a r f .
► Put protective gloves on before starting
work.
B l o c k a g e s c a u s e d b y a b r o k e n t o o l :
Switch off the machine. Remove plug
‹
from the mains socket.
Use the handle to move the machine
‹
slide to the upper position.
Replace defective tool. Remove swarf.
‹
Ot h e r b l o c k a g e s :
Switch the machine off using the motor
‹
switch. Leave the magnetic clamp
switched on.
Use the handle to move the machine
‹
slide to the upper position.
Remove swarf and check tool.
‹
b r o k e n t o o l
1 7