C L E A N I N G; M A I N T E N A N C E; St O R A G E - CS Unitec MABasic 200 Instrucciones De Manejo

C l e a n i n g /

M a i n t e n a n c e

C l e a n i n g
W AR NING
► Switch off the machine and pull the
plug out of the mains socket before
starting maintenance and cleaning.
► When using compressed air for
cleaning, wear protective goggles and
gloves and protect other persons in the
working area.
ATTENTION
► Never immerse the machine in water
or other liquids.
A f t e r e v e r y u s e
Remove the inserted tool.
‹
Remove swarf and coolant residues.
‹
Clean the tool and the tool holder on
‹
the machine.
Clean the guide of the machine slide.
‹
Put the machine and accessories into
‹
the transport case.
M a i n t e n a n c e
W AR NING
Danger caused by unqualified repairs!
Unqualified repairs can lead to considera-
ble danger for the user and cause damage
to the machine.
► Repairs to electrical appliances may
only be carried out by the works
customer service or by specialists
trained by the manufacturer.
1 8
A d j u s t i n g t h e m a c h i n e s l i d e g u i d e
If the machine slide guide (9) exhibits too
much clearance, it must be adjusted. To do
this, proceed as follows:
Loosen the clamping bolts.
‹
Tighten the adjusting screws evenly.
‹
Tighten the clamping bolts again.
‹
R e p l a c i n g t h e c a r b o n b r u s h e s
Replacement of the carbon brushes
may only be carried out by CS Unitec or
by an authorized specialist workshop.
Unauthorized repairs will invalidate the
guarantee.
C u s t o m e r s e r v i c e / s e r v i c e
Should you have any questions on customer
service/service, please contact CS Unitec.
We will be happy to give you the address of
your nearest service partner.
S t o r a g e
S t o r a g e
If you do not intend to use the machine for a
longer period of time, clean it as described in
the section Cleaning. Store the machine and
all its accessories in the transport case at a
dry, clean and frost-free location.
M A B a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0