Control And Set-Up; Temperature Min/Max; Relative Humidity (Rh) Min/Max - TechGrow T-1 Pro Manual

By playing with the settings of the CO
stable atmosphere can be reached.
Factory settings:
CO setpoint 700 ppm;
•
2
CO hysteresis 50 ppm.
•
2

8. Control and set-up

All settings are made with the Push-and-Turn-Knob
(from now on: PTK). By pressing the knob you will enter
the main screen. An arrow appears on the left side of the
display, allowing you to select the desired option.
During start-up the TechGrow T-1 Pro displays the next
screen:
TechGrow
T-1
Pro-Series
Software v. 2.13
After a few seconds, the set-up menu is displayed:
System settings
CO2 Setup
CO2 calibration
>> HOME <<
You can read more about this menu further
on in the manual.
After a few seconds the main screen is displayed:
CO2 = 950
CO2 set 700
CO2 +/- 50
Min 950 Max 962
The lower Min / Max line is alternated with the
"CO counter 00:12:25", and possibly dosing delay
2
(mode dawn) / dosing time (mode day), see section 8.5:
CO2 = 950
CO2 set 700
CO2 +/- 50
CO2 counter 00:12:25
In the main screen you can see all relevant CO
glance. The "CO2 counter" indicates how long CO
been dosed during the current cycle (that day).
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
hysteresis, a Access the main menu by pressing the PTK once:
2
Here, you can read all the actual values of the connected
sensors. Without connecting an S-2 or S-4, the CO
value will not be displayed.
By turning the PTK, you can put an arrow in front of the
different lines. Press the PTK once to learn more about
this specific function.

8.1 Temperature min/max

You are in the main screen. Press the PTK.
Select "TMP" and press the PTK.
Minimum/maximum values are displayed:
These measurements will not be stored in case of a power
failure.
To reset the min/max values, select "Reset min/max" and
press the PTK.
Select >> NEXT >> and press the PTK to return to the
main screen.

8.2 Relative Humidity (RH) min/max

data at a
2
You are in the main screen. Press the PTK and select
has
2
"RH".
TMP = 21.8 °C
RH = 63 %
CO2 = 848 PPM
Dose log
=> TMP = 21.8 °C
RH = 63 %
CO2 = 848 PPM
Dose log
TMP Min 21.2 °C
TMP Max 22.2 °C
Reset min/max
>> NEXT >>
TMP Min 21.2 °C
TMP Max 22.2 °C
=> Reset min/max
>> NEXT >>
2
17