Co : Setpoint And Hysterese; Pulse Dosing - TechGrow T-1 Pro Manual

TMP = 21.8 °C
=> RH = 63 %
CO2 = 848 PPM
Dose log
Minimum/maximum values are displayed:
RH Min 61 %
RH Max 67 %
Reset min/max
>> NEXT >>
These measurements will not be stored in case of a power
failure.
To reset the min/max values, select "Reset min/max" and
press the PTK.
RH Min 61 %
RH Max 67 %
=> Reset min/max
>> NEXT >>
Select >> NEXT >> and press the PTK to return to the
main screen.
8.3 CO : setpoint and hysterese
2
You are in the main screen. Press the PTK and select
"CO2".
TMP = 21.8 °C
RH = 63 %
=> CO2 = 848 PPM
Dose log
You enter the next screen where you can set the desired
CO level (setpoint) and hysteresis (+/-):
2
CO2 level 700
CO2 +/- 50
>> NEXT >>
Adjusting setpoint
=> CO2 level 700
CO2 +/- 50
>> NEXT >>
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
Select "CO2 level" (setpoint) and press the PTK.
Turn the knob until the desired CO
reached.
Press the PTK to confirm or wait a few seconds for
automatic confirmation.
Adjusting hysteresis
CO2 level 700
=> CO2 +/- 50
>> NEXT >>
Select "CO2 +/-" (hysteresis) and press the PTK.
Turn the knob until the desired value is reached.
Press the PTK to confirm or wait a few seconds for
automatic confirmation.
Select >> NEXT >> to proceed with setting the pulse
dose function.

8.4 Pulse dosing

The T-1 Pro has a pulse dose option, which enables
pulse dosed addition of CO
This option allows you to set the pulse and pause time
yourself. Moreover, it significantly tributes to creating a
stable CO level in your room.
2
Select >> NEXT >> to enable the pulse function and set
the pulse and pause time.
CO2 level 700
CO2 +/- 50
=> >> NEXT >>
Press the PTK to enter the next screen:
CO2 pulse Off
Pulse pause 01m00
>> NEXT >>
Select "CO2 pulse" to disable (Off) or set the pulse dose
period.
Select "Pulse pause" to adjust the interval between CO
additions.
Press the PTK to confirm.
The red CO LEDS indicate whether dosing is active or
2
not.
concentration is
2
.
2
18
2