Playing Back/Deleting The Photos/ Videos - Tasco Trail Cam 119422 Manual De Instrucciones

PLAYING BACK/DELETING THE PHOTOS/
VIDEOS
After you have setup, mounted and activated your Trail Cam, you will of
course be eager to return later and review the images it has captured for you.
There are several different ways this can be done.
Reviewing Images Directly From the SD Card
This is the most popular method of viewing images. Since unmounting the
camera and taking it to your computer isn't very convenient, you may find it
easier to just take the card out. By removing the SD card (swapping it for a
new empty card if you like) and taking it to your home or campsite to view
the images by using an SD card "reader" (user supplied) connected to your
computer (some computers and TVs have a built in SD card slot), you can
leave the camera in place ready to capture more images. Once connected,
the card reader works the same way as described below-please read that
section if you have any problem finding your files.
Reviewing Images on an External Video Monitor
A TV monitor can also be used to play back pictures (or videos) from the
device. Connect a TV monitor or a viewing device (such as a digital picture
frame) that has a standard composite video input (RCA jack) to the Trail
Cam 's "AV Out" mini jack using the supplied cable. Then:
• Put the power switch in SETUP mode (switch
to OFF first).
• Press the OK key. The most recently captured
image will be shown on the video monitor. For
video clips, press the SHOT (RIGHT) key to
start playing, press again to stop.
• Press the UP key for the previous photo or
video and the DOWN key for the next one.
When viewing images, the total number of all
images in the SD card and the index of the
displaying image are shown in the center of
LCD and at the bottom of the video monitor
respectively.
• Press the OK key to return to live preview state (SETUP mode) when
playback is finished.
22
Cable from "AV Out"