Installation; Operating Voltage; Connections - Dedicated Micros drx 400 Manual De Instalación

3. INSTALLATION

OPERATING VOLTAGES:
The drx 400 requires that all connections to the p.c.b. be made by the installer via terminal blocks
or by plug and socket.
The connections are:
For the listed connections see the Connection Table on pages 6 & 7
The drx 400dc is supplied pre-configured to suit the application for which it is intended i.e. 24 Volt d.c.
drives for pan & tilt heads or surveillance domes
The unit is pre-wired for 230 Volts a.c. supply with 230 Volt a.c. auxiliary outputs

CONNECTIONS:

The following p.c.b. layout and table shows all the connector and terminal block locations and the
required input and output connections.
drx 400d.c. Installation Manual
Power
Video in & Video out
Alarm in & Alarm out
Pan & Tilt outputs
Auxiliary output
Lens drive
Pre-sets
drc400dc pcb layout
Page. 6