Cleaning The Hood - Sirius S-DD2 Istrucciones De Uso

4/ CLEANING THE HOOD

Careful maintenance helps guarantee proper operation and good results from an appliance
over time.
The hood must be unplugged from the electrical power source, both by unplugging
the appliance from the socket as well as de-activating the breaker, before removing the
metal filters. After cleaning, you must replace the metal filters as outlined in the instruc-
tions.
MAINTENANCE
External surfaces and acces-
sories
Filter cartridge
Active carbon filter
HOW TO PROCEED?
Do not use metallic scrub-
bers, abrasive products, or
hard brushes.
After 30 hours' operation,
the button pad will signal
that the grease filter is sa-
turated by flashing the 4
speed LEDs. Press the timer
button to reset
In the recirculation mode,
you must substitute the acti-
ve carbon filter periodically.
To remove the fibre panel you
must first remove the anti-
grease grill and pull the pla-
stic knob on the panel itself,
removing it from its housing.
To replace the active carbon
filter, do the reverse. Replace
the used carbon filter on an
average of every six months.

ACCESSORY PRODUCTS TO
To clean the external sur-
faces of the hood and the
light housing screen use
only commercially available
household detergents dilut-
ed in water. Then rinse with
clean water and dry with a
soft cloth.
The grease filters can be
washed by hand or in the
dishwasher.
need to be cleaned on a re-
gular basis because other-
wise they may present a fire
risk. Refit the grease filters
and front panel, making sure
.
that the panel is properly
fitted at the sides so that it
does not cause the down-
draft to stop operating.
GB
USE
These filters