Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKPBESSUREWASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
7.
Attach spray tip extension to spray gun.
8.
Select/attach Quick Connectspray tip to spray tip
extension.
Attach Handle and Accessory Tray
1.
Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
3.
Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
*
Main Unit
*
Handle
*
Accessory Tray
*
High Pressure Hose
*
Spray Gun
*
Spray tip Extensionwith Quick Connect Fitting
*
Bottle BracketWireform (2)
*
PerfectMixTMSiphoning U nit/Hose
*
StandardSiphoning Hose
*
Oil Bottle
*
Parts Bag (which includes the following):
*
Operator's Manual
*
Owner's Registration Card
*
Safety Goggles
*
Bag containing 4 multi-colored Quick Connect
Spray tips
*
HandleFasteningHardwareKit (which includes):
*
Carriage Bolts (2)
*
Plastic Knobs (2)
,
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle, accessory tray and bottle brackets.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect pressure hose to spray gun and pump.
6.
Connect water supply to pump.
NOTE:It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriagebolts (D) through holes d bottle brackets.
Attach bottle brackets (E) to outside of handle with
carriage bolts and black plastic knobs (F). Tighten by hand.
Placeaccessory tray (G) over holes (H) on handle
(viewing from front of unit). Push the tree clips (J) into
the holes until they sit flat against the accessory tray.
Publicidad
Tabla de contenido
