Comeup Seal 9.5i Manual De Usuario página 4

There are three control modules of the Comeup automotive winches. All are similar in setup, but have
differing responses in regards to their control type.
Determine which model you have and refer to the charts for you particular models signalling of its
condition through LED's and buzzer
Wired Remote Control Module
Available Winches
LED Locations
Plug in Connector
Cable In/Out Operation
Motor Overheating Warning
Plug Out Connector
Available Winches
Wireless Control Module on the dual control modules
They can be controlled by the wireless control module or the wired remote control module, but only
one control way can activate the winch at the same time.
Available Winch
LED & Buzzer
Press Transmitter for 5 seconds
Cable In/Out Operation
Motor
Overheating
Warning
Low Voltage on Transmitter
Warning
Poor Signal Warning
Available Winches
.
LEDs on the bridge control box
Left LED
Green
Green
LEDs and buzzer on the bridge control box
Left LED
Green
Green
Cable In/out
Red
No Working
Seal 9.5i/9.5si; DV-9i/9si
Right LED
Green
Green
Red Red
LED turns off
Seal 9.5rsi
Right LED
X
Blue
Blue
X
X X
X Blinking Blue
3
Control Indicator Guide
LEDs on the remote control
LEDs
Green
Green
Red
Seal 9.5 / 9.5s/12.5/12.5s
DV-18/15/12/9/9s
DV-12 light/12s light
LED on the
Buzzer
transmitter
X
X
2 short Beeps
every 5 seconds
X Blinking Green
X Blinking Red
Seal 9.5rs / 12.5rs
(Buzzer in the control box)
wireless
Green
Red
Red
Green