Comeup Seal 9.5i Manual De Usuario página 9

Clutch Repositioning
Change the position of the Free-Spool T-handle according to the following steps.
1. Loosen and release the bolts on the brake rear cover for separating the brake rear cover away.
2. Loosen and release the bolts on the gearbox away for separating the gear box away (Only for
Seal series winches).
3. Rotate the gearbox by a proper angle increments mentioned on the below chart to the required
position.
4. Re-assembly the gearbox and rear brake cover.
Mounting Configurations
The payout direction for wire rope/synthetic rope or the correct methods for mounting the winch
vary according to different winch model. Do wind the rope from the bottom of the drum for foot
down mounting winch. Do wind the rope from the top or bottom of the drum towards the direction of
the mounting base plate for foot forward mounting winch. At any condition, do not position the load
direction away from the mounting base plate.
Winch Model
Seal 9.5/9.5s/9.5rs
Seal 9.5i/9.5si/9.5rsi
Seal 12.5/12.5s/12.5rs
DV-18
DV-12/15
DV-12 light/12s light
DV-9/9s/9i/9si
DV-6000S
Foot Down Mounting Position
Mounting Position
Foot Down Foot Forward
V
V
V
V
V
8
Clutch Angle
90∘
V
90∘
V
90∘
V
36∘
V
36∘
V
40∘
V
40∘
V
V
Foot Forward Mounting Position
Mounting Guide
Repositioning
Motor Angle
90∘
90∘
90∘
90∘
90∘
90∘
90∘
90∘