How To Assemble Your Ceiling Fan - Fanimation Levon FP7910 Serie Manual De Instrucciones

1. Remove the hanger ball portion from the downrod
/hanger ball assembly by loosening the set screw
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and
hanger ball for reinstallation in Step 6 (Figure 1).
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4 (Figure 2).
3. Loosen the two set screws in the downrod support.
Route black, blue and white lead wires through the
downrod (Figure 3).
4. Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip.Tighten the two set screws
and locking nuts in the downrod support (Figure 4).
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through motor coupling cover and
canopy (Figure 5).

How to Assemble Your Ceiling Fan

Downrod
Set Screw
Hairpin
Clip
Downrod Support
Set Screws and
Locking Nuts (2)
6
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, Blue and
White Leads
Downrod
Figure 3
Downrod
Clevis Pin
Hairpin Clip
Figure 4
Canopy
Motor Coupling
Cover
Figure 5