Parts identification
1. Main Unit
Switch
A
F
Battery cover
B
F
2. Blade on Rear Side
Downy hair blade
C
F
Blade release button
D
F
3. Eyebrow blade
4. Eyebrow comb
5. Cap
6. Cleaning brush
7. Soft carrying case
Inserting the battery
(Battery sold separately.)
Be sure to remove the battery cover
only after the switch is off.
1. Insert one AAA alkaline battery.
Note: Insert the battery in the
correct polarity.
2. Attach the battery cover.
Attaching and removing
the blade
(Figs. 3 and 4)
(Attach the downy hair blade or
eyebrow blade according to the area
to be trimmed.)
■ Removing the blade (Fig. 3)
1. Support the head of the trimmer
with your finger so that it does not
swing excessively.
2. Slide the blade release button in
the direction of the arrow.
3. Remove the blade in the direction
of the arrow.
■ Attaching the blade (Fig. 4)
1. Support the head of the trimmer
with your finger so that it does not
swing excessively.
(Fig. 1)
(Fig. 2)
5
2. Attach by inserting the projection at
the tip of the facial trimmer into the
hole of the blade.
3. Slide the blade release button in
the direction of the arrow.
Trimming downy hair
(Use the downy hair blade)
■ Holding the blade to the skin
(Fig. 5)
• Lay the blade against the skin.
• Slowly move the blade against the
flow of the hair.
■ How to trim (Fig. 6)
Slowly move the facial trimmer in the
direction of the arrow for the areas to
be trimmed.
1. Above the eyebrows
Move from the hairline to the center
of the forehead.
Then back to the hairline.
2. Cheek
Move outward from the center of
the face.
3. Upper lip
Stretch your upper lip and move up
and down.
4. Sideburns
Decide on the length of the
sideburns and trim downward.
5. Below the eyes
Hold the skin with your fingers and
move outward from the center.
6. Nape
Hold the skin with your fingers and
move upward.