Kenmore trio 596.76502500 Guía De Uso Y Cuidado página 11

Door Re[nstaHation
1. Install hinge assemblies:
Install top hinge loosely with 5A/' hex head
screws.
Install center hinge with Phillips
screws.
2. Place hinge side of refrigerator door
on center hinge pin.
3. While holding refrigerator door /
upright, tighten down top hinge
d
with %/' hex head driver.
4. Reconnect two-pin connecton
5. Replace top hinge covers.
Fresh Food Handles
Materials Needed:
Gloves to protect hands.
Phillips screwdMven
Plastic door removal card (or YX' thick plastic card}.
Retain the card.
To UnstaJJ:
1. The handles are to be oriented
as shown.
2, Align front mount door handle
clip with the door tabs.
3. Ensure the handle clips are
positioned slightly above the
door tabs.
andle
"!Jp
Door
Tab
4. Rotate the handle so that the
handle is flat against the door.
5. Push the handle down against the
upper door tab just enough to
allow it to hang unsupported.
.
Align bottom of handle with lower _C_
door tab. Press upper handle end to _
door surface and firmly grasp lower
end of handle. Gently slide handle /I
upward until bottom of handle
settles on door surface, then
reverse direction, sliding downward
to almost engaging tab with clip.
Grasp the handle firmly and slide
down until it clicks. The audible
click indicates fastening clips are
securely interlocked.
To Remove:
I,Flex the handle away from the door
panel. Simultaneously place door
handle removal card underneath
the base of the lower handle. Insert
the card to the line or until it stops.
2. Grasp the lower part of the handle
firmly and lift to remove.
11