Description And Use - Unox LineMiss XAF-193 Manual Del Usuario

UNO
If during the 45 seconds of flashing digits (0.00) the
operator set a time (using the + or – keys), the oven
automatically starts functioning (with temperature
and percentage of humidity entered in the last used
step).
At the end of the 45 seconds or if the cooking cycle
is interrupted by pressing the START / STOP keys,
all the parameters previously set will turn into 0 (the
operator will be in the same situation there is when
the oven has just been turned on) and the START/
STOP LED will be switched off.
Automatic pre-heating
An automatic pre-heating phase is run only when
you use the oven with programs.
When you start the program with the START / STOP
key, the oven starts to heat up the cavity and you do
not see any digit on the displays. When the oven
reaches the pre-heating temperature, it gives a long
sound. At this point, it is necessary to open the door,
place the trays with the food to be cooked inside the
oven and close the door: the chosen program will
start automatically.
Pre-heating temperature is equal to the set
temperature plus 30°C.
MANUAL WATER
While the oven is working (both in the manual and
in the programmed mode) it is possible to introduce
water inside the cavity by pressing the "MANUAL
WATER" key. The electric water valve works only for
the time the key is pressed.
3.3 DESCRIPTION AND USE OF Manual
CONTROL BOARD
COOKING TIME SETTING
Time of cooking can be set by turning clockwise
the knob situated on left side of the control board:
time range is 0 -120 minutes.
By turning the knob anti-clockwise the oven works
continuously.
By turning the knob you start the oven: the fan
spins and internal light turns on.
When cooking time is over, the knob turns to "0"
position and the oven turns off.
ENGLISH
10
R
COOKING TEMPERATURE SETTING
The cooking temperature inside cooking chamber
is set through the temperature knob ( on right side
of control board ): temperature range is 0 – 260 °C.
Temperature warning light on indicates that heating
element is on; when set temperature is reached, the
light turns off.
ENGLISH