Shindaiwa 270 Serie Manual Del Propietário página 8

Assembly (continued)
Trimmer Head T270/C270
NOTE:
The T/C 270 is shipped with Holder A,
the blade retainer, Holder B, and also the
shaft bolt and bolt guard installed. The
shaft bolt is a LEFT-HAND thread and is
removed in a CLOCKWISE ROTATION.
1. Position the gearcase with the out-
put shaft facing up and remove both
holders.
2. Position Holder A as shown and slide it
onto the gearcase shaft. See Figure 11.
3. Install and center the safety clip on the
gearcase shaft. See Figure 11.
4. Install Holder B on the gearcase shaft.
The machined boss on Holder A must
engage with the recess on Holder B.
See Figure 11.
5. Rotate the gearshaft and holders until the
hole in Holder A aligns with the matching
hole in the gearcase flange, and then lock
the holder to the gearcase by inserting
the long end of the hex wrench through
both holes. See Figure 12.
6. Using a counter-clockwise rotation
and hand pressure alone, thread and
securely tighten the trimmer head into
the gearcase shaft. See Figure 13.
7. Remove the hex wrench from the
gearcase and holders.
8
Figure 11
Holder B
Hex Wrench
27016
Figure 12
The T270 should now be completely assembled.
Install Holder
A
Install Holder
27014
27014
Holder A
Hand-tighten
trimmer head
Figure 13
Safety Clip
B
27017