Installation Instructions; Asembling The Blade - Sima EUROTRON PLUS Manual De Instrucciones Original

6. INSTALLATION INSTRUCTIONS

6.1 ASEMBLING THE BLADE

The circular saw blades, meet the safety requirements of EC standards. Fully support the maximum number
of revolutions indicated compliance with safety standards.
In case of change discs, always check that discs are steel with carbide teeth and the measures necessary for
the machine model.
A suitable disc ensures a great performance at the machine and a better functioning of the same, so we
recommend using only original blade.
To mount the blade we proceed as follows:
1 Make sure the table saw is not connect to the power supply.
2 If we are going to change the blade and the protection blade is on, we will lift it to the maximum point and
hold that position with the help of an object. IF IT NOT NECESSARY TO REMOVE THE PROTECTION BLADE IN
ORDER TO CHANGE THE DISK.
3 Loosen the screw T, Fig.2 of grooved plastic lid P, Fig.2 and remove it up and move forward to get it out
of position.
4 Block the rotation of the motor shaft by introducing the key punch A, Fig.2 in the drill that incorporates this
axis, and loosen the nut C, Fig.2 with the hexagonal key D, Fig.2 the motor shaft nut is threaded anticlockwise.
5 Remove the outer flange B, Fig.2 and place the disk, taking into account the sense that it must turn and is
identified in the direction of the tooth cutting. The direction of the arrow drawn in the protection of the disc, must
match the direction of the arrow on the disc, and in turn, with the direction of rotation of the engine.
In the event that the motor rotation is different from that indicated for three-phase motors and then switching
the motor direction of rotation of two threads sharing each phase at the air base or the extension cord plug for
connection to the power supply.
Warning: Check the proper coupling between the flanges and the disc, taking care that the key external flange
becomes lodged in the groove presents the motor shaft, thereby preventing the disk to rollover the shaft.
Now you can definitely tighten the nut (left-hand thread) from fixation.
6 then proceed in the reverse order that was followed to reach this point.
WARNING: Remove the tool used, before starting the machine and make sure all pieces are in the correct
position.
5
ENGLISH