Adjusting The Spool Position; Welder Controls; Front Panel Operation - Forney 242 MIG Manual De Operación

seems to feed smoothly without slipping.
4. Close the wire drive cover on the spool gun.
5. When set correctly, there should be no slippage between the wire and the drive roller under
normal conditions.

Adjusting the Spool Position

Before you begin welding, you may want to adjust the position of the spool so it is most comfortable for
you. There are three positions to choose from. To change the position of the spool:
1. With a flat tipped screwdriver, loosen the screw connecting the spool casing to the gun.
2. Pull the casing far enough away from the gun to allow the casing to rotate.
3. Rotate the casing to one of the three available positions, making sure the grooves on the gun
are aligned with the grooves on the casing.
4. Push the casing and the gun back together.
5. With a flat tipped screwdriver, tighten the screw which connects the spool casing to the gun.

Welder Controls

With welders in the digital series, thanks to a special electronic card it is possible to externally adjust
the welding parameters. The main purpose of these units is to make adjustment of these parameters
very easy.
The microprocessor control handles the functions of the p.c.board that are viewed by means of LED's
while a digital display shows the parameters set and welding current. Units may be used either with the
standard torch (supplied with them) or with the Spool Gun.

Front Panel Operation

1. Main ON/OFF switch (green):
Lights up when you switch ON the welder on.
2. Welding voltage adjustment knob
3. Spool Gun connection
4. Wire feed adjustment knob
To increase the wire speed, turn the
potentiometer clockwise; to decrease the wire
speed, turn it counter-clockwise. The same
procedure decreases the values on the welding
parameters. Turn knob slowly.
5. Spot welding time regulation knob
MIN. 0.4 seconds - MAX. 10 seconds
6. Welding "MODE" selector key
Use these keys to select the following types of
welding:
- 2T: 2 time welding = manual
- 4T: 4 time welding = automatic
- Automatic spot welding with timer
16
13
14
1
2
12
WWW.FORNEYIND.COM
8 7 5 6
242 MIG
1 2
1
3
11 9 10 4
500
400 600
250 700
150 800
50 900
0 1000
2
4
35
21.3
22.7
24.3
48.3 26.2
42.4 28.4
37.7 31.0
34.0