Removing The Battery; Charging The Battery - Pantech HotShot Guia Del Usuario

REMOVING THE BATTERY

1. To remove the battery cover, insert your finger tip
into the slot (1), then push down on the top of the
battery cover and slide it off (2).
2. Insert your fingernail into the slot and lift the battery
from the compartment.
3. Align the cover tabs with the slots on the back of the
phone and slide the battery cover onto the unit until
it snaps into place.

CHARGING THE BATTERY

1. Connect the USB data cable into the cableless wall
adapter.
2. Plug the USB data cable into the phone' s Charging/
Data Port (making sure to align the connector as
it appears in the image to the right) and the wall
adapter end into an electrical outlet.
18
If the battery connector is not properly aligned, damage could occur to the charging
connector and the phone may not be charged.
Correct
Correct Incorrect
3. To remove the wall charger, unplug the USB data
cable from the phone' s Charging/Data Port.
When you charge the battery with the handset
powered off, you will see a charging status screen.
After charging is completed, the Charge Complete
message appears and you cannot operate the phone
until it is powered on. To turn your phone on, press and
hold the Power Key until your display turns on.
The battery may not be fully charged at the time of
purchase. Fully charge the battery before using.
It is more efficient to charge the battery with the
handset powered off.
Battery operating time gradually decreases over time.
If the battery fails to perform normally, you may need
to replace the battery.
Incorrect
01
02
03
04
05
06
07
08
19