Fuel And Oil; Fuel Supply - Truper PRETUL RECE-160P Instructivo

Motor
axis
Oil cap with
oil level
measuring rod

Fuel and oil

Oil supply
• Verify the oil level: Remove the oil cap with oil level
measuring rod (A) and wipe it clean. Set the cap in place
again but do not thread it. Remove the cap once more and
check oil level.
• If oil level is close to or below the lower limit marked in the
measuring rod, fill up with oil up to the oil level marked in
the measuring rod barely touches the upper limit markedSet
the cap back and thread it.
CAUTION
• The motor can seriously get damaged
with no oil. Always check oil level before operating the
mixer. The mixer shall always sit on level ground to correctly
measure the oil level.

Fuel supply

• Set the mixer onto flat and leveled surface.
• Clean and dry the area around the fuel cap.
• Remove the fuel cap (B).
• Using a funnel fill up the fuel tank slowly up to the
maximum level mark.
• Clean any fuel spilling.
• Close the cap turning it until hearing a click.
• Clean any fuel spills before starting the mixer.
10
ENGLISH
Fuel
Fuel tank
tank
cap
Switch
Choke
lever
Air filter
cover
Automotive
Oil SAE 10W-30
A
Parts
Pulley
Starter
B
Spark plug
cable
Muffler
Clean
unleaded
gasoline