Technical Data - EINHELL KGS 250 Manual De Instrucciones

damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly.
Unless otherwise stated in these instructions,
damaged safety devices and parts must be
repaired or replaced by experts in an approved
specialist workshop.
Have damaged switches replaced by a customer
service workshop.
This tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
for the user (ear-muffs).
Sound pressure level LPA 100,4 dB(A)
Sound power level LWA
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
Cutting Idling
91,7 dB(A)
111,4 dB(A) 102,7 dB(A)
operations. Reliable workplace values may also
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."

5. Technical data

Asynchronous motor
Power rating
Operating mode
Idle speed n0
Carbide saw blade
Number of teeth
Standing area
Tilting range
Mitre cuts
Saw bed support
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
6. Before putting the machine into
operation
The machine has to be set up where it can s
firmly, e.g. bolt it to a work bench, a universa
base or similar.
All the covers and safety devices have to be
properly fitted before the machine is switche
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodi
such as nails or screws etc.
Before you actuate the On/Off switch, make
that the saw blade is correctly fitted and that
machine's moving parts run smoothly.
Before you connect the machine to the powe
supply, make sure the data on the rating plat
the same as that for your mains.
G
230 V 5
14
4500
ø250 x ø16 x 2,5
445 x
-47° / 0° /
0° to 45° to th
450 x 160
135 x 70
100 x 70
100 x 70