Electrical Connection; Wiring Diagrams - Eaton Cooper Lighting PORTFOLIO LCRWM8AX Instrucciones De Instalación

6. Install the LED Engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 7 .).
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint-free cloth.

Electrical Connection

CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C (Figure 8.).
2. Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3. Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly.

Wiring Diagrams

For DE010 Driver (Option 1) (Consult Web Page For Product
Availability)
GRAY(-)
VIOLET(+)
WHITE(N)
BLACK(LINE)
120V-220V
0-10V GRAY(-)
DIMMING
VIOLET(+)
WHITE(N)
BLACK(LINE)
120V-220V
BLACK(LINE)
120V-220V
WHITE(N)
VIOLET(+)
GRAY (-)
Installation Instructions – LCRWM8AX* Commercial LED Rough-In
BLACK(-)
LED
RED(+)
DRIVER #1
4 5
GREEN CONNECTOR
1 2
RED W/WHITE
STRIPE (+)
LED
BLACK W/WHITE STRIPE (-)
DRIVER #2
Installation Instructions – LCRWM8AX* Commercial LED Rough-In
705476BINS ADP140596 www.eaton.com
Torsion
Spring
Figure 7.
GREEN/BARE COPPER
Figure 8.
For DE010 Driver (Option 2) (Consult Web Page For Product
Availability)
TO GROUND
RED FOR 277V
BLACK FOR
BLACK FOR
277V BLUE
120V
FOR 120V
6
BLK
BLK
P-NUT P-NUT
3
WHITE
P-NUT
VIOLET
GRAY
LINE
BLACK
NEUTRAL
WHITE
GROUND
RED
BLK
BLK
WHT WHT
GRN
VIOLET
VIOLET
GRAY
GRAY
BLUE
CONDUIT
P-NUT
P-NUT
CONNECTOR
BLK
BLK RED
RED
WHT
WHT
GRN
VIOLET
VIOLET
GRAY
GRAY
BLK
P-NUT
BLUE
Torsion
Spring
Receivers
LED 2
RED
+
-
BLK
P-NUT -
RED/W
P-NUT
1 1
4 4
2 2
5 5
LED 1
+
RED
-
BLK
3