Electrical Connection; Wiring Diagram - Eaton HALO HCC Serie Manual Del Usuario

Wiring Diagrams and Instructions – HCC4, HCC6, HCC8 & Commercial LED Rough-In
Figure 11.
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry lint-
free cloth.
Dimming
The Halo Commercial HCC4/HCC6/HCC8 LED luminaire can be dimmed however updates in dimmer technology and special
conditions may apply depending on the dimmer type being used. For the latest information regarding dimmers for use with
this LED luminaire, please see the Halo Commercial HCC4/HCC6/HCC8 LED Dimming Reference Sheet at www.eaton.com.
In addition, you may wish to consult the dimmer manufacturer for their latest dimmer configurations and product information.
4
EATON
IB517029ML Installation instructions

Electrical Connection

Make certain no bare wires are exposed outside of wire nut
connectors.
1. Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C.
2. Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using
properly sized wire nuts. Be careful not to leave any
bare conductors outside of the wire nut connectors.
3. Connect white to white, black to black, and green (from
electrical service) on the supply side to the green wire
in the cylinder housing assembly.

Wiring Diagram

D010 Driver
BLACK (LINE) BLACK (LINE)
0-10V DIMMING
WHITE WHITE
DRIVER
(NEUTRAL) (NEUTRAL)
GROUND
RED
RED
BLUE
LED
PURPLE
BLACK
GRAY
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)