Assemble The Platter System; Connect And Start Djing - Rane ONE Guia Del Usuario

Setup

1. Assemble the Platter System

1. Remove the ONE base from the packaging. Remove the platter assemblies
from the package (underneath ONE). Place ONE on a flat, stable surface
for assembly and operation.
2. Place the platters onto each deck of the ONE base by aligning the pins in
the bottom of the platter with the holes in ONE's motor. Press it down
firmly. Check to make sure that it rotates uniformly and does not wobble
excessively.
3. Place the slipmat onto the platter. Then place the Control Disc over the
spindle (with the attached Quick Release Adapter on top). To lock the
Control Disc to the spindle, pinch the top of the spindle while slowly
rotating the disc until you hear it click. It locks when the groove in the
spindle lines up directly opposite to the button on the side of the Quick
Release Adapter.

2. Connect and Start DJing!

1. Make sure you have downloaded and installed the latest version of your DJ software.
2. Place ONE on a flat, stable surface.
3. While the power is switched off, plug the included power cable into ONE first, then plug the
cable into a power outlet.
4. Power on ONE using the power switch.
5. Use a standard USB cable (included) to connect the USB Port to an available USB port on your
computer or a powered hub connected to the computer.
6. Open Serato DJ Pro and go!
For more information on how to use Serato DJ Pro with the ONE, please visit
support.serato.com.
Example
Items not listed under Introduction > Box Contents
4
are sold separately.