Clean The Sliding Lids; Cleaning Of Glass Treated With Adhesive Film; Inspect The Parts - Arneg Bergen 2 Guía De Instalación Y Manejo

Bergen 2
English
Remedy recent stains and rust:
clean with shampoo or neutral detergents, using a sponge or a rag.
When finished, eliminate any detergent residue, rinse and thoroughly dry the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
This intervention may however cause scratches to the surfaces due to the abra-
sive cleaning method. DO NOT use hydrochloric acid on stainless steel surfaces
CAUTION! Slippery floor. Falling.
Remove from the floor any items such as sponges, rags, waste of water or detergent.
Carefully clean any residue of detergent or sanitizer.
i
Carefully follow the sanitizing, rinsing and drying procedures to prevent proliferation of
harmful bacteria.

22.9 Clean the sliding lids

Respect the chapters (chap.21.1.), (chap.21.2.), (chap.21.5.) and proceed as described:
Step
1 lift and remove the closures, use both hands and wear safety gloves
2 gently place them on a flat surface, DO NOT break or damage them
3 3 clean as indicated for the cleaning of glass parts (chap.21.5.)
4 reinstall the closures

22.10 Cleaning of glass treated with adhesive film

• Observe the cleaning instructions for normal glass parts.
DO NOT apply stickers on the side with film.

22.11 Inspect the parts

Once you have completed sanitizing, rinsing and drying, proceed as follows:
Step
1 check that all parts are perfectly clean and dry
2 check that they are not damaged or too worn
3 replace worn parts with new ones provided by the manufacturer
4 install the parts perfectly dry
5 restore electrical power supply
Once the internal operating temperature has been reached, it is possible to load the products.
42
Action
Action
05060176 00 11-09-2018