Error Messages - KBL mon amie Manual De Instrucciones

Error messages

Statusmes-
sage KBL/4
E00: Hardware Error
E01: BUS: Error fan
speed control
E02: BUS: Error
temperature sensor
E03: Maximum
tanning time.
E04: BUS: Error
vocie mp3-player
E06: BUS: Error
easyCare relay
module
E07: BUS: Error
I²C-Bus
E08: Excess tempe-
rature bimetal
E12: BUS: Error
mon amie Terminal
38
M a n u a l d e i n s t r u c c i o n e s | mon amie
Status description
Main board defective.
Faulty communication between Mainboard
and fan-speed control.
I 2 C Temperature sensor defective or malfunc-
tioning.
Enabling signal from coin-box system comes
in longer than the time value approved under
"Maximum tanning time" (voltage remains con-
nected) .
Data exchange between control and Voice
MP3 Player disturbed.
Communication between control and easy-
Care relay has been interrupted.
I²C bus system defective.
Bi-metal switch triggers.
Communication between control and mon
amie terminal has been interrupted.
Remedy
Replace the main board (contact your Customer Service).
Check / replace the patch cable. If the fault persists, contact your
Customer Service..
Check / replace the patch cable. If the fault persists, contact your
Customer Service.
Disconnect from the coin-box system.
Check „Voice" SD Card. Check / replace the patch cable. If the fault
persists, contact your Customer Service.
Check / replace the patch cable. If the fault persists, contact your
Customer Service.
Check / replace the patch cable. If the fault persists, contact your
Customer Service.
Check the air-intake/air-discharge system and the fan. Let the tan-
ning system cool down and acknowledge the message by pressing
the START button. If the fault persists, contact your Customer Ser-
vice.
Check cable connections and power supply. Acknowledge the mes-
sage by pressing START. If the fault persists, contact your Customer
Service.