Installation; Mattress Installation; Power Unit Installation - Bio Clinic OrthoDerm LAL Operación Manual

BIO CLINIC
POWER PATIENT WIEIGHT
6
LBS
L O w A i r L O S S M At t r e S S r e p L A C e M e n t S y S t e M
300 1000
260 900
ON
220 800
180 700
150 610
STANDBY
120 520
CPR
100 430
80 350

4
rear panel Features:
Fuse ():
Fuse holders can be opened with flat head
screwdriver to inspect or change fuses.
hanging hooks ():
Hanging hooks are designed to fit mul-
tiple foot board widths. Hooks are spring
loaded and will fold against the power
unit when not in use.
Air Filter and Filter Cap ():
No tools are necessary to remove filter
cap. Sunrise Medical recommends that
the filter should be inspected and cleaned
or replaced with a Genuine Bio Clinic re-
placement part once a month to ensure
optimal performance of the power unit.
Filter and filter caps sold separately.
Serial number Label (4):
Label identifies serial number along with
agency approvals, etc.
MODE
STANDARD UPRIGHT
80-300 lbs
MODE
BARIATRIC
350-1000 lbs
PANEL
LOCK


MAX
INFLATE
ON
OFF

8.0 inStALLAtiOn

Mattress and power unit installation:
1. Remove existing mattress from hos-
pital/homecare bed frame and store.
2. Place the OrthoDerm LAL mattress
replacement on the bed frame with
the silk-screened Bio Clinic logo fac-
ing up and the hose end at the foot
section of the bed frame.
mattress replacement to each side of
the bed frame using mattress anchor
straps with D-rings. Anchor straps
should be attached to the bed frame
in a fashion that will not hinder the
bed frame articulating up and down.
Attached anchor straps should be
tucked
ment to avoid any complications.
NOTE: Before proceeding, test
all bed functions to verify no restric-
tions or interference.
3. Using the integrated hanging hooks,
securely hang the power unit on the
bed end at the foot end or place on a
smooth flat surface.
4. Connect the air hoses from the mat-
tress replacement to the power unit.
5. Plug the power unit into a wall outlet.
Refer to section 3.0 of this Manual
("Warnings") for proper instructions.
Be sure the power cord is safely away
from possible hazards (eg foot traffic,
bed tables, lifters, etc).
6. Turn on the power switch on the side
panel of the power unit. The system
will be in Standby/CPR mode. Press
the Power button on the control
panel. The power unit will begin to
inflate the support surface. Max In-
flate function may be used to rapidly
inflate the support surface prior to
use by the patient. See section 7.0 of
this Manual ("Features").
under mattress
Secure
replace-