Hilti AG 500-A22 Manual De Instrucciones Original página 13

Status
2 LEDs light.
1 LED lights up.
1 LED blinks.
Note
Indication of the charge status is not possible while the power tool is in operation or immediately
after operation. If the battery charge status LEDs blink, please refer to the information given in the
Troubleshooting section.
4 Consumables
Only synthetic resin-bonded, fiber-reinforced discs with a maximum Ø of 5" which are approved for use at a
rotational speed of at least 11000/min and a peripheral speed of 80 m/s may be used.
The maximum grinding disc thickness is 1/4" and the maximum cutting disc thickness is 1/8".
WARNING! When cutting or slitting with abrasive cutting discs always use the standard guard with
the additional front cover, or a fully enclosing dust hood.
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Wire brushes
Suitability of discs for the equipment used
Item Equipment
A Guard
B Front cover (in
combination with
A)
C DG-EX 125/5" dust
hood for grinding
D DC-EX 125/5"C dust
hood for cutting (only
in conjunction with A)
E Side handle
F DCBG 125 hoop
handle (optional for
E)
G Clamping nut (not for
use with accessories
with integrated
thread)
H Clamping flange
(not for use with
accessories with
integrated thread)
Printed: 26.01.2017 | Doc-Nr: PUB / 5292877 / 000 / 00 Printed: 26.01.2017 | Doc-Nr: PUB / 5292877 / 000 / 01
Meaning
•
•
•
Application
Cutting, slitting
Cutting, slitting
Rough grinding
Rough grinding
Wire brushes
AC­D AG-D AF-D
X X X
X — —
— — —
— — —
X X X
X X X
X X X
X X X
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
Designation
AC­D
DC-TP, DC-D (SPX,
SP, P)
AG-D, AF-D, AN-D,
AG-D type 27
DG-CW (SPX, SP,
P)
3CS, 4CS, 3SS,
4SS
AN-D DG- DC-TP,
CW DC-D
(SPX, (SPX,
SP, P) SP, P)
X X X
— — X
— X ­
— ­ X
X X X
X X X
X X X
X X X
Material
Metal
Mineral
Metal
Mineral
Metal
3CS, AG-D
3SS, type 27
4CS,
4SS
X —
— —
— —
— —
X X
X X
— —
— —
7