Technical Data - Hilti TE 2 Manual De Instrucciones Original

4 Technical data

Note
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Weight
Drilling diameter range in con-
crete/masonry (hammer drill
bit)
Drilling diameter range in con-
crete/masonry (hammer drill
bit)
Drilling diameter
range in wood (solid)
Drilling diameter
range in wood (solid)
Drilling diameter
range in metal
(solid-head drill bit)
Drilling diameter
range in metal
(solid-head drill bit)
Maximum length of the depth
gauge
Maximum length of the depth
gauge
5 Operation
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the
clamping band is engaged in the groove in the tool.
TE 2-M
Fitting / removing the chuck
Fitting/removing the drill bit or other accessory: SDS chuck
Note
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
TE 2-M
Fitting/removing the drill bit or other accessory: Quick-release chuck
Printed: 04.10.2017 | Doc-Nr: PUB / 5261120 / 000 / 01
TE 2 TE 2-S
6.0 lb 6.0 lb
(2.7 kg) (2.7 kg)
3/16 in ...7/8 in 3/16 in ...7/8 in
4 mm ...22 mm 4 mm ...22 mm
3/16 in ...3/4 in 3/16 in ...3/4 in
•/• •/•
4 mm ...20 mm 4 mm ...20 mm
•/• •/•
3/16 in ...1/2 in 3/16 in ...1/2 in
•/• •/•
3 mm ...13 mm 3 mm ...13 mm
•/• •/•
7 in 7 in
180 mm 180 mm
TE 2­M
6.4 lb
(2.9 kg)
3/16 in ...7/8 in
4 mm ...22 mm
3/8 in ...3/4 in
3/16 in ...3/8 in
10 mm ...20 mm
4 mm ...10 mm
5/16 in ...1/2 in
3/16 in ...5/16 in
8 mm ...13 mm
3 mm ...8 mm
7 in
180 mm
2
3
4
5
English 5