Items Supplied; Technical Data - Hilti TE 7-C Manual Del Usuario

3.3 Items supplied

Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com

4 Technical data

Note
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Weight
Ø Hammer drill bits
Ø Hammer drill bits
Ø Drill bits for wood
Ø Drill bits for wood
Ø Drill bits for metal
Ø Drill bits for metal
5 Operation
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the
clamping band is engaged in the groove in the tool.
Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
Note
The function selector switch should be set to the
the chuck.
Fitting / removing the accessory tool
Note
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
Adjusting the depth gauge
Drilling without hammering
Drilling with hammering action (hammer drilling)
Chiseling
Printed: 10.10.2017 | Doc-Nr: PUB / 5071225 / 000 / 03
TE 7­C
7.7 lb
(3.5 kg)
1/4 in ...1 1/8 in
5 mm ...28 mm
3/16 in ...3/4 in
3 mm ...20 mm
≤ 13 in
≤ 13 mm
"Chiseling" position when changing
2
3
4
5
6
6
6
English 5