Stihl MS 260 Manual De Instrucciones página 56

Engfish / USA
• Always file from the inside to the
outside of the cutter.
• The file only sharpens on the
forward stroke -
lift the file off the cutter on the
backstroke,
• Avoid touching the tie straps and
drive links with the file,
• Rotate the file at regular intervals
while filing to avoid one-sided wear,
• Use a piece of hardwood to remove
burrs from cutting edge,
• Check angles with the filing gauge,
All cutters must be the same length.
If the cutters are not the same length,
they wilt have different heights. This
makes the chain run roughly and can
cause it to break.
Find the shortest cutter and then file
all other cutters back to the same
length. This can be very time
consuming - it is best to have it
done in the workshop on an electric
grinder.
Depth gauge setting
I
a
t
The depth gauge determines the height
at which the cutter enters the wood and
thus the thickness of the chip removed.
Specified distance or setting between
depth gauge and cutting edge = a:
This setting may be increased by 0.2mm
(0.008") for cutting softwood in mild
weather season - no frost.
Chain pitch
Inch (mm)
1/4
(6.35)
3/8 PMN (9.32)
3/8 PM,
PMMC3 (9.32)
0.325 (8.25)
3/8 (9.32)
0.404 (10.26)
Depth gauge
setting "a"
mm (inch)
0.65 (0.026)
0.45 (0.018)
0.65 (0.026)
0.65 (0.026)
0.65 (0.026)
0.80 (0.031)
Lowering depth gauges
The depth gauge setting is reduced
when the chain is sharpened.
• Use a filing gauge to check the
setting every time you sharpen the
chain.
1 __ .............. /_ ................ z
{o
Place a filing gauge (1) that
matches the chain pitch on the
chain - if the depth gauge projects
from the filing gauge, the depth
gauge has to be lowered.
"\\\
! ................ /i
/ /
\\ \ 1
_o
• File down the depth gauge until it is
level with the filing gauge.
MS 260 55