Inspection And Maintenance; Inspection And Operation Checkpoints / 8.2 Maintenance - Honeywell Miller MightEvac Manual De Instrucciones Para El Usuario

8.0 Inspection and Maintenance

8.1 Inspection and Operation Checkpoints
WARNING: The user must perform the following operation checkpoints and
inspections prior to each use. In addition, a competent person must inspect
equipment at regular intervals, at least annually.*
[*ANSI Z359.14 provides additional inspection requirements based on type of use and conditions of use. Refer
to 6.1 Inspection and Appendix A: Inspection Requirements for compliance with the standard.]
CAUTION: Always wear gloves when inspecting wire rope/cable units;
broken strands can cause injury!
cracked, distorted, worn, malfunctioning or damaged parts.
a. With the device in the mounted position, test the lifeline retraction and tension by pulling out several
feet of the cable and allow to retract back into the unit. Always maintain a light tension on the cable
as it retracts. The lifeline should pull out freely and retract all the way back into the unit.
If the lifeline does not pull out smoothly or sticks when retracting, pull all the cable out of the
housing and allow it to retract slowly under tension. Do not use the unit if the lifelines does not
retract properly.
b. The lifeline should be checked regularly for signs of damage. Inspect entire length for cuts, burns,
corrosion, kinks, frays, worn areas, broken strands or chemical damage.
the load indicator and applying a sharp steady pull downward which will engage the brakes.
There should be no slippage of the lifeline while the brakes are engaged. Once tension is
released, the brakes will disengage and the unit will return to the retractable mode.
Inspect the snap hook closely for damage, distortion,
cracks, corrosion, or pitted surfaces. The snap hook gate (keeper)
should seat into the nose without binding and should not be bent,
the gate from opening when closed. The snap hook swivel should
operate smoothly.
The load indicator is located in the swivel of the snap hook. The
swivel eye will elongate and expose a red area at the location
illustrated when subjected to fall arresting forces.
working properly according to the operation instructions (see section 4.0 of this manual).
UNITS THAT DO NOT PASS INSPECTION OR HAVE BEEN SUBJECTED TO
THE FORCES OF ARRESTING A FALL OR AFFECTING A RESCUE
Us er In stru ctio ns - Engli sh
The braking mechanism can be tested by grasping the lifeline ABOVE
Inspect the load indicator for signs of activation.
Ensure that the retrieval mechanism and associated components are
Make sure that all labels and markings are present and legible.
MUST BE REMOVED FROM SERVICE.
Inspect the unit for loose fasteners and bent,
14
Load Indicator
AFTER