Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Completion of Charge
Charge completion is indicated by the CHARGED (green) LED. When lit, the charger
has switched to the Maintain Mode of operation. If the 12V DEEP CYCLE battery type
was selected, the CHARGED (green) LED comes on when the battery is charged
enough for normal use.
Maintain Mode (Float-Mode Monitoring)
When the CHARGED (green) LED is lit, the charger has started Maintain Mode. In this
mode, the charger keeps the battery fully charged by delivering a small current when
necessary. The voltage is maintained at a level determined by the BATTERY
TYPE selected.
notE: The maintain mode technology utilized in DieHard chargers allows you to safely
charge and maintain a healthy battery for extended periods of time. However, problems
with the battery, electrical problems in the vehicle, improper connections or other
unanticipated conditions could cause excessive voltage draws. As such, occasionally
monitoring your battery and the charging process is recommended.
using the Engine Start feature
Your battery charger can be used to jumpstart your car if the battery is low. Follow these
instructions on how to use the ENGINE START feature.
Follow all safety instructions and precautions for charging your battery.
Wear complete eye protection and clothing protection. Charge your battery in a well-
ventilated area.
Using the ENGINE START feature WITHOUT a battery installed in
the vehicle could cause damage to the vehicle's electrical system. notE: If you have
charged the battery and it still will not start your car, do not use the engine start feature,
or it could damage the vehicle's electrical system.
1.
With the charger unplugged from the AC outlet, connect the charger to the battery
following the instructions given in section 6: FOLLOW THESE STEPS WHEN
BATTERY IS INSTALLED IN VEHICLE.
2.
Plug the charger AC power cord into the AC outlet.
3.
With the charger plugged in and connected to the battery of the vehicle, set the
charge rate selector button to the engine start position.
4.
When the display shows
the engine does not start, wait 3 minutes until the display shows rdy before cranking
again. This allows the charger and battery to cool down.
notE: During extremely cold weather, or if the battery is under 2 volts, charge the
battery for 5 minutes before cranking the engine.
5.
If the engine fails to start, charge the battery for 5 more minutes before attempting to
crank the engine again.
6.
After the engine starts, unplug the AC power cord before disconnecting the battery
clips from the vehicle.
7.
Clean and store the charger in a dry location.
notE: If the engine does turn over but never starts, there is not a problem with the
starting system; there is a problem somewhere else with the vehicle. STOP cranking the
engine until the other problem has been diagnosed and corrected.
Engine Starting notes
During the starting sequence listed above, the charger is set to one of the following
three states:
Wait for cranking – The charger waits until the engine is actually being cranked before
delivering the 80 amps for engine start. The charger delivers charge at a rate of up to 12
amps while waiting. While waiting for cranking, the digital display will show rdy.
Cranking – When cranking is detected, the charger will automatically deliver up to its
maximum output as required by the starting system for up to 3 seconds or until the
engine cranking stops. The digital display shows a countdown of the remaining crank
time in seconds. It starts at 3 and counts down to 0.
rdy, crank the engine until it starts or 3 seconds pass. If
7
•
•
Publicidad
Tabla de contenido
