Tool Specifications; General Safety Practices - Panduit PTH Manual De Operación

© Panduit Corp. 2016
INTRODUCTION
The PTH Tool installs Panduit Standard (S), Heavy-Standard (HS),
Light-Heavy (LH) and Heavy (H) cross section cable ties. The tool
pneumatically tensions the cable tie to a tool-controlled tension,
and cuts off the tip.

TOOL SPECIFICATIONS

Weight: 32 oz. (907 gr.)
Dimensions*: 11.18" (284mm) Long X 6.81" (173mm) High
* Dimensions in parentheses are metric; all dimensions are
approximate, and for reference only.

GENERAL SAFETY PRACTICES

• For multiple hazards, read and understand the safety
instructions before
maintaining, changing accessories on, or working near the
pneumatic tool. Failure to do so can result in serious bodily
injury.
• Only qualified and trained operators should install, adjust or use the pneumatic tool
• DO NOT modify this pneumatic tool. Modifications can reduce the effectiveness of safety measures and increase the risks
to the operator
• DO NOT discard the safety instructions; give them to the operator
• DO NOT use the pneumatic tool if it has been damaged
• Tools shall be inspected periodically to verify that the ratings and markings required by this part of ISO 11148 are legibly
marked on the tool. The employer/user shall contact the manufacturer to obtain replacement marking labels when
necessary
• DO NOT use tool for purposes not intended. Unexpected tool movement or breakage of tool may cause injuries to hand
• Unsuitable postures may not allow counteracting of normal or unexpected movement of the tool
For multiple hazards, read and understand the safety instructions before installing, operating, repairing,
maintaining, changing accessories on, or working near the pneumatic tool.
Safety glasses must be worn at all times by all persons within ten (10) feet of any part of the system.
CAUTION: Be aware of the ejection of cable tie scrap from tool.
DO NOT use tool on live electrical sources.
CAUTION! Pinch Point. Keep hands and fingers clear.
DO NOT use tool in an explosive atmosphere.
Ear protection should be worn when operating the tool.
PNEUMATIC TOOL OPERATION MANUAL
installing, operating,
PTH
repairing,
1. Tension Indicator
2. Selector Knob
3. Quick Disconnect Fitting
Page: 1 of 20
PA25023A01
Rev: 01 2-2016
PTH Pneumatic Tool
4. Trigger
5. Nose
6. Gripper