Important - Suzuki GSF 650 K9 Serie Manual De Instalación

Ref. Description
Contents
1 Plug & play harness
2 Sticky wired led 35 cm
3 7,5A fuse
4 Fixing bi-adhesive tape 7x5,5x0,3 cm
5 Fixing bi-adhesive tape 2x2x0,6 cm
6 Tie rap 141 mm
7 Installation instructions
Ref. Description
Tools
1 Screw driver PH3
2 Cutting nipper
3 SUZUKI owner's manual
Please read this manual and follow its instructions carefully. To emphasize special information, the

Important

symbol and words
to the messages highlighted by these signal words.
WARNING
Caution
Note
Caution
Certain technical experience is required for the mounting. If you are not sure how to carry out the work you should
leave it to be done by your SUZUKI dealership.
1. Preparation before installation
a) Park the motorcycle steady in a safe place.
b) Keep the ignition key removed.
c) Be sure not to damage any vehicle part.
d) Check that all the parts are contained in the kit as listed in "Contents" section.
2. Installation
a) Dismount the seat.
b) Disconnect the battery negative pole.
c) Insert deeply the 18-pin harness connector in the alarm unit up to the security catch is clicking.
d) Apply the fixing bi-adhesive "4" on the bottom of the control unit.
e) Remove the bi-adhesive plastic film.
f) Apply the four bi-adhesive tapes "5" as indicated in picture 1.
g) Place the control unit as indicated in picture 2. Press for a few seconds.
Note: It could be necessary to repack the on board tools that all longer tools are located left in the tool map.
h) Route the plug&play harness over the frame (picture 2
(picture 3
i) Secure the plug&play harness to the frame by a tie rap (picture 2
j) Remove the original OE-jumper of the 4-pin alarm connector and connect the plug&play harness counterpart.
k) Connect the 1-pin connector (picture 3
2
WARNING, CAUTION and NOTE have special meanings. Pay special attention
Indicates potential hazard that could result in death or injury.
Indicates potential hazard that could result in vehicle damage.
Indicates special information to make maintenance easier or Instructions clearer.
B).
SUZUKI GENUINE ACCESSORIES
Q.ty
1
1
1
1
4
4
1
(1)
A) to the 4-pin connector of the motorbike harness
A) (+12V) to the plug&play harness counterpart.
(2)
B).
(3)